§ 16.16.710. Duties of certificate holders.

A.

It shall be the duty of the certificate holder to assure that the gas/mechanical work for which he/she is responsible is installed in accordance with all requirements of the metropolitan gas/mechanical code in addition, the certificate holder must comply with all applicable state laws.

B.

The certificate holder shall be responsible for all work for which a permit was obtained under his/her certificate and to request and secure all inspections.

C.

No gas/mechanical work shall be begun until a permit has been obtained by the certificate holder.

D.

It shall be the responsibility of the certificate holder and the gas/mechanical contractor to immediately notify the board in writing if his employment is terminated for any reason or he is unable to perform his duties.

E.

The certificate holder shall promptly notify the gas/mechanical contractor of any deficiencies in the work as identified to him/her in writing by a metropolitan gas/mechanical inspector. It shall be the responsibility of the certificate holder to promptly correct such deficiencies in the work. A certificate holder shall not furnish permits for gas/mechanical work to any person, firm or corporation other than the registered gas/mechanical contractor with whom his/her certificate is registered.

F.

Failure to comply with any of the duties listed above shall constitute grounds for suspension or revocation of the certificate holder certificate.

(Ord. 90-1253 § 1 (part), 1990; prior code § 19-1-101)