Metro Government of Nashville and Davidson County |
Code of Ordinances |
Title 6. BUSINESS LICENSES AND REGULATIONS |
Division I. General Regulations |
Chapter 6.75. PEDICABS AND PEDAL CARRIAGES |
Article III. Equipment and Operation |
§ 6.75.320. Vehicle requirements.
A.
Each pedicab in operation must meet the following minimum specifications:
1.
Unibody frame construction;
2.
Three wheels;
3.
Rubber on all wheels;
4.
If the pedicab is a rickshaw, it shall not have a width of more than fifty inches and length of no more than ten feet;
5.
A fully operational horn or bell;
6.
Headlights that have a beam of at least three hundred feet;
7.
Flashing taillights that are visible from at least five hundred feet;
8.
Mirror(s) affixed to the pedicab to reflect to the driver a view of at least two hundred feet from the rear of the pedicab;
9.
Turn signals affixed to the front and rear of the vehicle;
10.
Reflectors on the spokes of all wheels, front pedicab frame, and a red reflector mounted on each side of the rear of the pedicab, at least one inch from the outer edge and centered;
11.
Hydraulic, mechanical disk, or drum brakes that are unaffected by wet conditions and that control the front and rear of the pedicab;
12.
No more than one trailer may be attached to any pedicab and must be equipped with turn signals and red tail lights, provided that no passengers shall be transported in a trailer at any time;
13.
Body painted with bright, reflective paint;
14.
Clean and maintained in a good state of repair. All pedicabs shall be maintained by the certificate holder so as to be well painted and have a damage or deterioration free appearance, and in safe operational condition; and
15.
If electric motor assistance is installed, it must meet all manufacturer standards and be inspected by a certified mechanic on an annual basis.
B.
Each pedal carriage in operation must meet the following minimum specifications:
1.
Unibody frame construction;
2.
Four wheels;
3.
Rubber on all wheels;
4.
A fully operational horn or bell;
5.
Headlights that have a beam of at least three hundred feet;
6.
Flashing taillights that are visible from at least five hundred feet;
7.
Mirror(s) affixed to the pedal carriage to reflect to the driver a view of at least two hundred feet from the rear of the pedal carriage;
8.
Turn signals affixed to the front and rear of the vehicle;
9.
Working running lights along the outermost parts of the front, sides, and rear of the vehicle so as to make the vehicle clearly visible to motorists at night;
10.
Hydraulic, mechanical disk, or drum brakes that are unaffected by wet conditions and that control the front and rear of the pedal carriage;
11.
Trailers are prohibited from being attached to pedal carriages;
12.
Body painted with bright, reflective paint;
13.
Clean and maintained in a good state of repair. All pedal carriages shall be maintained by the certificate holder so as to be well painted and have a damage or deterioration free appearance, and in safe operational condition; and
If electric motor assistance is installed, it must meet all manufacturer standards and be inspected by a certified mechanic on an annual basis.
(Amdt. 1 to Ord. BL2014-925 § 1, 2014; Ord. BL2014-925 § 1, 2014)